Atlas Horizontal Milling Machine, 2 Table Thrust Plates & 3 V-Belt Pulleys, Used

Description

Atlas horizontal milling machine,
2 table thrust plates and 3 V-belt pulleys plus belt.  Good used condition as pictured and as described below:
Table thrust plates: They bear the numbers M1-116 and M1-116A. Each includes two locating pins, a bronze bushing and two mounting screws (not pictured). The M1-116 is cracked through on one side of the central hole. This crack is opposite the reference mark stamped on the outside surface of the bracket for the graduated collar. The crack could be a manufacturing defect caused by stamping the reference mark too hard, or perhaps someone cracked it by over-tightening the mounting screws and the crank handle. The longitudinal table feed worked fine before I disassembled it, so the crack does not affect the function of the bracket.
Pulleys: The picture of the three pulleys shows (1) the motor pulley on the right, (2) the countershaft pulley that carries the belt from the motor pulley in the middle, and (3) the countershaft pulley that carries the belt to the spindle on the left. Pulley 1 has a 1/2 inch diameter hole; pulleys 2 & 3 have 5/8 inch diameter holes. Pulley 2 stands higher in the picture than pulley 3 because there is an attached set screw mounting boss out of sight underneath it. As seen in one picture, pulley 2 actually consists of two separate pulleys that mount next to each other on the shaft. The hole in the pulley on the top is shimmed with a sleeve to make it fit tightly on the shaft. All the pulleys include their set screws. I don't know if these are the original pulleys for this machine, but they worked fine when I ran the motor. I will also include the motor belt, since I don't have any use for it.
Buy it now price includes shipping to Ontario, Canada.
I have other
Atlas horizontal milling machine parts.