KM59M Kamir Tubular Motor for Rollup Shutters Standard 100 NM 11 rpm

Description

Excellent Standard Tubular Motor with mechanic limits and manual override, four wires.
KM59M-100
120V 60Hz, 100 Nm 11 Rpm
4
wires cable (black, red, white an green).
Motor diameter size 59mm.
Lift Capacity: Octagonal Tube 60 mm 493 Lbs, Octagonal Tube 70mm 448 Lbs, Octagonal Tube 80mm 410 Lbs, Octagonal Tube 100 mm 308 Lbs
It comes with 1 brackets,  1 crown 70 mm, 1  drive adapter 70 mm, 1 limit adjuster.
Please make sure you know how to install the motor, consult with a professional and read all the instructions carefully.
All Motors are fully tested before they leave our warehouse.
Customers buying from:
Florida will require to pay Sales Tax.
Alaska, Arizona, California, Hawaii, Oregon and Washington; there is an additional charge for the delivery of $ 28.00
Puerto Rico and US Virgin Islands, there is an additional charge for the delivery of $ 28.00
The additional small charge will be billed later through PayPal invoice after you pay the motor, sorry for the inconvenience.
Instructions on how to program the Kamir motors KM35R-6, KM35R13, KM45R-20, KM45R-50, KM45RM-50, KM45RMA-50, KM59R-100 KM59M-100 and KM59RM-100 with manual limits:
1- Take off the back cover of the remote and place the battery. Make sure the battery on the remote control is good. You can verify that by pressing any of the front buttons and some light should be seen.
2- To engage the remote control. Connect the motor to a power supply; you will hear a long beep then
3- In the back of the remote control there is a P2 button you are going to press it twice; every time you should hear a beep from the motor.
4- Then on the front of the remote control press the up or down button until you hear a long beep the motor is linked with your remote.
5- If you press the up or down buttons on the remote the motor should move.
6- If the direction is wrong, just disconnect the power supply from the motor wait 60 sec and power it back. Repeat steps 3 and 4 with the different direction than you did before.
7- You need to make sure the motor is correctly attached to the tube in order for the limits to work. After that you can set you limits with the plastic adjuster, make sure you do this manually.
DO NOT USE A POWER TOOL TO DO IT.