POWER FEED USA Steel

Description

This is the
original
CRANK YANKER.
Made in the USA
of exceptional quality.
Elevate and lower your milling table with
just a
trigger
pull of your half-inch drill.
Saves production time. Saves your arm and shoulder. Saves your
$$$$
.
No need to spend hundreds of dollars on an installed motorized knee lift.
CNC machined from
1018 cold rolled steel
for a perfect interface with your machine. No burs. Not a casting.
Not soft aluminum
.
Nickel Plated
for corrosion resistance and a great look.
Hex Shank to prevent slipping in the drill chuck.
Lifetime warranty.  Only positive feedback.
Can pay for itself in an hour.
Just read my feedback.......
Here is a recent, actual review by a busy machinist:
"This is the most simple and functional tool. I have several different operations I perform on my mill and the table has to move a great deal up and down. At times more than 8 inches. I keep a battery operated drill with this chuck in it by the mill now all the time. I can raise or lower the table in just a few seconds and save my arms, back and shoulders the pain of cranking the Z axis over extended distances. High quality, easy to use and a great time saver. You won't be disappointed!"
MADE IN THE USA
Makes a great gift!!!!!
Dedicate a quality drill motor to it........you will use it often.
Fits Bridgeport and others with a 9-cog interface, Tool has .625" center bore, 1-1/2" deep.
This adapter will work on
Bridgeport, Comet, Enco, Supermax, Victor,
Jet, Alliant, Acer, Sharp, Chevalier, and Webb.
Check your machine against the above dimensions.
Also available w/ 1/2" deeper bore (contact me through eBay)
-------
PayPal  only
------
No E-Checks
Listing is for one tool. Drill or Mill ;-) shown is not included. Only the tool.
Ships via Priority Mail  - Same Day
On Nov-27-09 at 11:24:35 PST, seller added the following information:
On Nov-13-13 at 08:04:15 PST, seller added the following information: